Max TA238A/18-6 Manuel d'utilisateur télécharger pdf (Page 9)

1 Press the button on the trigger.

2 Turn the switching lever in the direction of the arrow.

3 Set the switching lever as above picture.

CONTACT TRIP

The common operating procedure on "Contact Trip" tools is for

the operator to contact the work to actuate the trip mechanism

while keeping the trigger pulled, thus driving a fastener each time

the work is contacted.

All pneumatic tools are subject to recoil when driving fasteners.

The tool may bounce, releasing the trip, and if unintentionally al-

lowed to recontact the work surface with the trigger still actuated

(finger still holding trigger pulled) an unwanted second fastener

will be driven.

DRIVING DEPTH ADJUSTIMENT DIAL

ALWAYS-disconnect air supply before adjusting adjustment

dial.

1 If a Adjustment is required, disconnect air supply.

2 Refer to the figure for direction to turn the dial.

3 Reconnect air supply.

Button

Switching lever

Trigger

Contact arm

Adjustment dial

WARNING

TA238A-USA.book 9 ページ２０１０年７月９日　金曜日　午後５時３７分

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Pas de commentaire

Max TA238A/18-6 Manuel d'utilisateur Page 9